Mechanical Installation - WEG DBW-01 Guía De Instalación, Configuración Y Operación

1. MECHANICAL INSTALLATION

The Dynamic Braking Module DBW is installed next to the CFW-09. For installing the
module, follow the guidelines bellow:
Step 1 Install the DBW braking module on a flat surface;
Step 2 Install the braking module on the vertical position and leave free space around it,
as indicated in figure 1;
Step 3 Install the DBW on the desired surface and securely fasten the holding screws
(figure 3).
(1.437in)
2
100mm
3.93in
WARNING - ONLY REMOVE TERMINAL COVER
AFTER 10 MIN. POWER HAS BEEN
DISCONNECTED.
- READ THE INSTRUCTIONS MANUAL.
- SOMENTE REMOVA A TAMPA
10 MIN. APÓS A DESENERGIZAÇÃO.
ATENÇÃO
- LEIA O MANUAL DE INSTRUÇÕES.
130mm
5.11in
Figure 1: Free Spaces for Cooling
150
(5.905in)
36,5
Dimension A
mm(in)
Figure 2: Dimensional Drawing of DBW-01 and DBW-02mm (inch)
223
(8.78 in)
WARNING
- ONLY REMOVE TERMINAL COVER
AFTER 10 MIN. POWER HAS BEEN
DISCONNECTED.
- READ THE INSTRUCTIONS MANUAL.
- SOMENTE REMOVA A TAMPA
10 MIN. APÓS A DESENERGIZAÇÃO.
ATENÇÃO - LEIA O MANUAL DE INSTRUÇÕES.
DBW-01 DBW-02
252 (9.92) 277 (10.91)
A