Hella Micro DE Instrucciones De Montaje página 11

Page 4/5: Final assembly
1. Insert bulb. Do not touch glass
on bulb with bare fingers (Fig. 1-2).
2. Connect positive lead (blue) to
bulb connector and earth lead
(brown) to retaining spring (Fig. 3).
3. Insert leads from lamp into
rubber grommet and install rubber
grommet so that it is against the
stop (drain fitting should always
point downwards) (Fig. 5).
11
Page 6:
Accessories
(not included with kit)
Mounting frame
4. Screw lamp onto preassembled
mount in correct position („TOP"
up, Hella legible, drain fitting
downwards), and tighten hand-
tight.
5. Reconnect earth lead (-) to
battery. Check lighting, align lamps,
tighten screws and securely fasten
connection leads.
Have the fog lamps adjusted in a
workshop or at a service station.
Only correctly adjusted lamps
provide optimum light without
dazzling oncoming traffic (Fig. 7).
If transmitter is lost, order
replacement from your authorised
dealer.
Important!
Code No. of your receiver!
Store the code card included in a
safe place.
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80 % of the light.
You drive safely when you can
see and be seen well. Do you
have spare bulbs and fuses in
the car? If you have any
questions or problems with
installation: Contact the Hella
Service Department.