KOBE CH-122 Serie Instrucciones De Instalación Y Manual De Operación página 18

Ocultar thumbs Ver también para CH-122 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If necessary, attach two rubber stands (provided) with two (4x8 mm) screws (provided) to
-
the back of the hood.
Attach the hood-mounting bracket to the back of the hood with nine (3/16" x 3/8") screws
-
(provided) as shown in Figure 25.
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn OFF the power on an
electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
1.
Using references on Table 2 and measurements on Page 22-23, mark the leveling point
of the hood. Position two mounting screws (not provided) on the wall, leaving 1/8" away
from the wall as shown in Figure 26.
2.
Use aluminum or steel pipe to connect the exhaust opening at the rear of the hood to the
ductwork. Use duct tape to make all joints secure and air tight.
3.
Align hood-mounting bracket to the two screws on the wall and hook hood into place.
Tighten screws to secure hood to the wall. CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 25
16
Mounting
Screws
Figure 26

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ch2230sqbCh2236sqbCh2230sqCh2236sq

Tabla de contenido