Control Panel; First Use - Zanussi ZBB 6286 Manual De Instrucciones

Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The

Control panel

Pilot Light
1
Temperature Regulator
2
Action Freeze light
3
Action Freeze switch
4
Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator clockwise to a medium
setting.
The Pilot Light will light up.
Switching off
To turn off the appliance, turn the Temperature Regulator
to the "O" position.
The Pilot Light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature Regulator toward higher settings
to obtain the maximum coldness.

First use

Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
4
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol are recyclable.
1 2 3 4
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Action Freeze function
Press the Action Freeze switch to activate the Action
Freeze function.
The Action Freeze light will light up.
Important! This function stops automatically after 52
hours.
Press the Action Freeze switch to deactivate the function at
any time. The Action Freeze light will switch off.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.