SOLAC BA5510 Instrucciones De Uso página 11

OPERATION
USE WITHOUT SUPPORT
A. FITTING THE RODS
• Before plugging the appliance into the mains, you should fit the appropriate
attachments depending on what kind of mixing you want to do:
- Mixer rods (9): For liquid mixes such as creams, egg whites, pastry mixes,
etc.
Fit 1 or 2 rods (9) in the coupling holes (4) by pushing them gently up
until they are fully engaged (fig.1).
- Blender rods (8): They are used for mixing light doughs.
• IMPORTANT: The blender rod with the metal washer should be inserted in
the wide hole (fig.2).
• When the attachments you are going to use have been set in place, plug
the appliance into the mains.
B. OPERATION
• Pick up the mixer and use your thumb to slide the selector (7) to the desired
position (fig.3):
- Position 0: Off
- Position 1-2: Low speed
- Position 3-4: Medium speed
- Position 5: High speed
• We recommend starting off at low speed and gradually increasing. For heavy
or thick mixes you should use high speed (nº 5) right from the start to pre-
vent the motor from locking.
• Make sure that the rods can turn perfectly inside the receptacle.
• The TURBO button (6) enables you to use the mixer at the highest speed
possible for a few seconds. For this purpose, with the speed selector (7) at
the desired position, keep the button (6) pressed for as long as you want it
to operate (maximum 30 seconds) (fig.4).
• When you finish mixing or want to interrupt the process, set the selector
(6) at position 0.
• To remove the rods (8 or 9) from the main body (1), press the release but-
ton (5) (fig.5).
• Do not press the button (5) while the appliance is working, as the rods
would drop out.
• When the process is concluded, unplug the appliance from the mains.
• The turbo cannot be switched on in position 0 for safety reasons.
5510 BATIDORA 11
11 11
20/1/05, 09:59:28