Additional Settings; Favourite Position (My); Adding/Deleting Somfy Io Control Points And Io Sensors; Modifying End Limits - SOMFY Sunea screen io Guia De Instalacion

7. ADDITIONAL SETTINGS

7.1. )DYRXULWH SRVLWLRQ P\
7.1.1. 3URJUDPPLQJ RU PRGLI\LQJ WKH IDYRXULWH SRVLWLRQ P\
The procedure to follow for programming or modifying the favourite position (my) is identical.
1) Put the awning in the desired favourite position (my).
2) Press the «my» button until the awning moves: the
desired favourite position (my) has been programmed.
7.1.2. 'HOHWLQJ WKH IDYRXULWH SRVLWLRQ P\
1) Press the «my» button: the awning will start to move, and stop in the favourite position (my).
2) Press the «my» button again until the awning moves: the favourite position (my) has been deleted.

7.2. Adding/Deleting Somfy io control points and io sensors

Refer to the corresponding guide.

7.3. Modifying end limits

0RGL¿FDWLRQ RI HQG OLPLWV GHSHQGV RQ WKH W\SH RI DZQLQJ
7.3.1. 0RGL¿FDWLRQ IRU YHUWLFDO DZQLQJV ZLWKRXW XSSHU VWRS DQG ODWHUDO DUPPRXQWHG
awnings
For vertical awnings without upper stop or lateral arm-mounted awnings without head rail, both
HQG OLPLWV PD\ EH PRGL¿HG
Readjusting the upper end limit
1) Position the awning at the upper end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning's top position using the Up or Down
buttons.
4) Press the «my» button until the awning moves: the new
upper end limit has been programmed.
Readjusting the lower end limit
1) Position the awning at the lower end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning's bottom position using the Up or
Down buttons.
4) Press the «my» button until the awning moves: the new
lower end limit has been programmed.
7.3.2. 0RGL¿FDWLRQ IRU YHUWLFDO DZQLQJV ZLWK XSSHU VWRS RQO\
For awnings with upper stop (load bar stopped under the head rail), the upper end limit is adjusted
DXWRPDWLFDOO\ ZKLOH WKH ORZHU HQG OLPLW FDQ EH PRGL¿HG
Readjusting the lower end limit
1) Position the awning at the lower end limit.
2) Press the Up and Down buttons simultaneously until the
awning moves: the motor is in setting mode.
3) Adjust the awning's bottom position using the Up or
Down buttons.
4) Press the «my» button until the awning moves: the new
lower end limit has been programmed.
Copyright © 2011 Somfy SAS. All rights reserved.
1 2
or
my
1 2
3 4
or
1 2
3 4
or
1 2
3 4
or
Sunea screen io
9