Control Point; Checking The Settings; Operation; Standard Operation - SOMFY Sunea screen io Guia De Instalacion

Sunea screen io
5.5. 3URJUDPPLQJ WKH ¿UVW 6RPI\ LR ORFDO FRQWURO SRLQW
5.5.1. Using a pre-programmed Somfy io local control
point
- %ULHÀ\ SUHVV WKH 352* EXWWRQ RQ WKLV FRQWURO SRLQW WKH
awning will make a brief movement; the control point has
been programmed.
5.5.2. After a single power cut
1) Press the Up and Down buttons simultaneously on the
new control point until the awning moves.
 %ULHÀ\ SUHVV WKH 352* EXWWRQ RQ WKLV FRQWURO SRLQW WKH
awning will make a brief movement; the control point has
been programmed.

5.6. Checking the settings

- Check the settings of the upper and lower end limits using the Somfy io local control point.

6. OPERATION

6.1. Standard operation

6.1.1. )DYRXULWH SRVLWLRQ P\
'H¿QLWLRQ
Besides the upper and lower positions, an intermediate position known as the «favourite position (my)»
may be programmed in the motor.
To program, modify or delete the favourite position (my), see the section «Additional settings».
To use the favourite position (my):
- %ULHÀ\ SUHVV WKH ©P\ª EXWWRQ WKH DZQLQJ ZLOO VWDUW WR
move, and stop in the favourite position (my).
6.1.2. STOP function
The awning is moving.
- %ULHÀ\ SUHVV WKH ©P\ª EXWWRQ WKH DZQLQJ ZLOO VWRS
automatically.
6.1.3. Up / Down buttons
%ULHÀ\ SUHVV WKH 8S RU 'RZQ EXWWRQ WR UDLVH RU ORZHU WKH DZQLQJ IXOO\

6.2. Operating with a Somfy io sensor

6.2.1. 2SHUDWLQJ ZLWK D 6RPI\ LR VXQ VHQVRU VXFK DV 6XQLV :LUH)UHHΠLR
Refer to the corresponding guide.
6.2.2. 2SHUDWLQJ ZLWK D 6RPI\ LR ZLQG VHQVRU VXFK DV (ROLV :LUH)UHHΠLR
Refer to the Somfy io wind sensor guide for details of its operation.
Reaction of the awning to the wind rising
When the wind rises, the awning will start to move up to
the upper end limit. It is impossible to prevent the awning
from closing, or to lower it while the wind is still blowing.
Reaction of the awning to the wind dropping
When the wind has dropped, a manual down order may
be issued via the io control point after 30 seconds. However,
all automated systems will remain locked for 11 mins.
6.2.3. Feedback
After each order, the Sunea io sends a message. This
response is processed by the io two-way control points.
8
PROG
1
my
30 s
Copyright © 2011 Somfy SAS. All rights reserved.
2
PROG
my