Motor/Tube Assembly; Installing The Tube-Motor Assembly; Wiring; Commissioning - SOMFY Sunea screen io Guia De Instalacion

3.3. Motor/tube assembly

1) Slide the motor into the roller tube.
 )RU VDIHW\ UHDVRQV ¿[ WKH UROOHU WXEH WR WKH GULYH ZKHHO
with 4 x Ø 5 mm self-tapping screws or 4 x Ø 4.8 mm
steel pop rivets located at least 5 mm from the outer rim
of the drive wheel (L1 - 5) and at most 15 mm from the
outer rim of the drive wheel (L1 - 15).
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.

3.4. Installing the tube-motor assembly

Insert the end-piece into the tube.
3.4.1. Star head motor:
1) Fit the tube/motor assembly to the end bracket (C).
2) Fit the tube/motor assembly to the motor bracket (D).
3.4.2. Round head motor:
1) Mount the support on the motor head, and then the
UHPRYDEOH ÀDQJH
2) 6OLGH WKH WXEHPRWRUUHPRYDEOH ÀDQJHV DVVHPEO\ LQWR WKH
head rail.

4. WIRING

Always make a loop in the power supply cable to prevent
water entering the motor!
Comply with current standards and legislation when
installing.
- Cut off the mains power supply.
- Connect the motor according to the information in the
table below:
230 V ~ 50 Hz
1 Brown Live (P)
2 Blue Neutral (N)
3 Yellow/Green
Earth ( )

5. COMMISSIONING

The guide only describes commissioning using a Situo io type Somfy io local control point. For
commissioning using any other io control point, refer to the corresponding guide.

5.1. Identifying setting steps already completed

Only one motor should be powered at a time.
Switch on the power and follow procedure «a» or «b»,
according to the awning's reaction:
Copyright © 2011 Somfy SAS. All rights reserved.
Motor cable
1
2 15 mm
L1
1 2
C
1
2
3 x 0,75 mm
1
230 V
2
~
3
50 Hz
2
3 x 1,5 mm
1
2
3
Sunea screen io
5 mm
20 mm
D
2
5