Husqvarna JONSERED LR 2107 C Manual De Uso página 22

ENGLAND
ASSEMBLY OF THE GRASS COLLECTION BAG
B
The grass collection bag is included with all models as a standard feature.
For assembly the following parts and tools are required:
Tools required:
- Phillips head screwdriver
- Wrench Ø 8
Parts:
- 4 screws M5x30 UNI 7688
- 4 M5 self-locking nuts
- Front frame for grass collecting bag
Assembly:
Fix the front frame of the grass collecting bag to the pre-assembled grass collecting bag frame.
Make sure that the front section of the grass collecting bag is in the correct position to ensure the correct operation of the grass collecting bag and of the tractor.
Insert the 4 M5x30 screws into the corresponding holes.
Screw and properly tighten screws and self-locking nylon nuts with tools.
Complete the assembly of the bag on the frame by connecting the grassbag rubber snap on hooks.
FRONT WHEELS ASSEMBLY (starts at page 119)
C
(NOTE: Some models come with pre-assembled wheels)
1 - Mount the front wheels on the axles (16), positioning a washer (17), the wheel (18) and a washer (19).
2 - Secure with circlip (20).
Tools required:
- Pliers
Parts:
- 4 washer
- 2 circlip
Attention: Assemble the wheel with valve outwards.
STEERING WHEEL ASSEMBLY (starts at page 120)
D
1
Tools required:
- Phillips head screwdriver
- Wrench Ø 10 mm
Parts:
- 1 screw M6x45 UNI 7687
- M6 Flanged Nut.
Assembly:
Insert the steering wheel on the steering tube and align the steering wheel hole with the steering tube hole.
Make sure that the steering wheel is in the correct position (Fig.D1).
- Insert the screw, screw and tighten the nut with the screw using the suitable tools.
NOTE: The steering wheel can be adjusted to two heights based on operator preference see D1.
ACCESS TO THE ENGINE COMPARTMENT (starts at page 120)
D
2
To remove the access cover to the engine compartment use a screwdriver and insert it into the appropriate slots of the engine cover until the two front
connections and the two rear connections are released.
SEAT ASSEMBLY (starts at page 120)
D
3
Tools required:
- Wrench Ø 13 mm
Parts:
- 4 screw M8x18
- 4 washer 9x24
- 4 lock washer Ø 8
1- Fasten the seat (1) to the support plate through the 4 M8 x 18 screws. Assemble with 4 washers Ø 9 x 24 and 4 lock washer Ø 8.
2- Before tightening the screws, adjust the position of the seat on the holes of the plate to suit the user's needs.
Regularly check the screw fixing.
(starts at page 119)
22