Engine Start - Husqvarna JONSERED LR 2107 C Manual De Uso

ENGLAND
STARTING UP
Before starting up check the oil and petrol levels.
Do not smoke during the oil and petrol refuelling and checking operations. Top up with petrol or oil if necessary (as described in detail in
the previous chapter).
Starting up (engine start) must be carried out as described in detail under the heading "initial starting up".
Never change gear while driving, the mower must always be at a standstill.
Never mow the grass with reverse gear engaged.

ENGINE START

(starts at page 104)
H
1
Look for a flat piece of ground with short grass for starting the engine.
Operate the electric start only when sitting on the tractor with the blade clutch (9) in stop position and with brake engaged.
1 - Set the clutch deck blade engage lever (9) to STOP position
2 - Set the throttle lever (7) to START position
3 - Press brake pedal (10) and put it into parking position.
ELECTRIC START (starts at page 122)
H
2
4 - Insert the ignition key in the ignition block (5)
5 - Turn the key to the right and release it, after starting in "RUN" position. The green light positioned beneath the steering wheel
control remains on. Should the engine fail to start within 5 seconds, to avoid damaging the battery, wait a further 10 ten seconds
before trying again.
PULL START
Put brake pedal into parking position.
Make sure that the cutting deck blade engage lever is not engaged.
Put accelerator lever into START position.
Grab the pull start rope (6) and pull it. Engine should start. - Repeat if necessary until engine starts.
After start up, sit on the seat and proceed to the work operations.
(starts at page 122)
H
3
6 - Set the lever (7) between
SWITCHING OFF THE ENGINE
ELECTRIC START
Turn off the engine by turning key to Stop. The green light will switch off.
Only switch the engine off when the machine is at a complete standstill.
Always remove the ignition key to prevent accidental starting.
PULL START
Turn off the engine by pushing accelerator lever (7) forward to STOP position.
MOVING WITHOUT POWER (starts at page 122)
H
4
Movement without power possible only with engine off. Before manually moving the unit, make sure the gear is in neutral.
Apply parking brake when finished.
DRIVING INSTRUCTIONS
Ensure that there are no persons or animals within the operating vicinity of the machine.
Select the required speed and drive carefully. Transportation of other persons is strictly forbidden.
DRIVING (starts at page 122)
I
1
1 - Press the brake pedal (10) which acts as a clutch, activate the lever (12) according to chosen gear, then slowly release the brake pedal (10) until
unit starts moving. To engage reverse gear, stop, and engage the reverse and engage the gear into reverse (R) by pressing the brake pedal (10), then
slowly releasing the brake pedal (10) again.
2 - The speed maybe varied by manually operating throttle lever (7).
CAUTION! During work or transfer phases, in case of upward/downward slopes, use 1
I BRAKING (starts at page 122)
2
Press the brake pedal (10).
To lock brake pedal (10) move lever to parking position.
The exhaust fumes contain carbon monoxide, an odourless and deadly gas. Never start the engine in closed or
badly ventilated rooms.
and until you judge the revs to be correct for your work
st
24
gear only.