Standard Accessories; Optional Accessories (Sold Separately) - Hitachi DH 40SR Instrucciones De Manejo

PRECAUTIONS ON USING ROTARY HAMMER
Wear earplugs to protect your ears during operation.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
SPECIFICATIONS
1
Voltage (by areas)*
Power input
Capacity
2
No load speed*
2
Full-load impact rate*
Weight (without cord, side handle)
1
* Be sure to check the nameplate on product as it is subject to change by areas.
2
* With constant velocity regulator.

STANDARD ACCESSORIES

(1) Case (Molded plastic) ................................................. 1
(2) Side Handle ................................................................. 1
(3) Stopper ........................................................................ 1
(4) Hammer Grease A ...................................................... 1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES (sold separately)

Through-hole drilling (Rotation + Hammering)
(1) Drill bit (hexagon shank)
Overall length: 280, 400, 505 mm
External dia.: 16, 19, 22, 25, 28, 32, 38 mm
Anchor hole drilling (Rotation + Hammering)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12, 14.3,
14.5, 17.5,
21.5 mm
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
(2) Taper shank
adapter
Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
950 W*
Drill bit: 40 mm
Core bit: 120 mm
510 /min
2800 /min
6.5 kg
Taper shank
Application drill bit
adapter
Morse taper Drill bit (taper shank)
(No. 1) 11, 12, 14.3, 14.5, 17.5 mm
Morse taper Drill bit (tape shank)
(No. 2) 21.5 mm
Taper shank adapter formed A-
A-taper
taper or B-taper is provided as
optional accessory, but drill bit for
B-taper
it is not provided.
Large dia. hole boring (Rotation + Hammering)
(Guide (1) Center
plate) pin
(1) Center pin
Applied to core bits from 38 mm to 105 mm
Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm or
29 mm)
(3) Core bit shank
Applied to core bits above 38 mm
Applied to core bits below 35 mm
Anchor work (for self-anchors)
English
1
(3) Core bit
(2) Core
bit shank
6