Brinkmann 810-3821-S Manual Del Propietário página 34

Step 16
Insert each main burner igniter lead wire
to each valve.
Step 17
Attach side burner assembly using four
M6 X 10 mm bolts, insert M6 X 10 mm
bolts halfway and then slide side burner
assembly down over bolts and tighten
securely.
Step 18
Loosen the two bolts with washers from
the bottom of the burner assembly
bracket. This will allow the burner to
move freely while performing Step 19.
Step 19
Remove two M4 bolts and washers
from the side burner valve. Insert the
side burner valve assembly through
the hole in the side burner front panel,
seat the valve nozzle into the burner
venturi. Hold in place while you
perform Step 20.
WARNING: Never use your grill
without leak testing all gas
connections and hoses.
See the section on "Leak
Testing" in this manual for
proper procedures.
33
Igniter Lead Wire
Valve
Burner
Burner Assembly/Bracket Bolts