Wiring Of Control Connections - Lenze L-force 9400 Serie Instrucciones Para El Montaje

6 Wiring the device
Wiring

Wiring of control connections

6.3.4 Wiring of control connections
24 V supply
Terminal X11
9400SSP000X2
Terminal data
Flexible
With wire end
ferrule
Stripping length / contact length: 10 mm
Digital inputs, digital outputs
Terminal X12
SSP9400X12
Terminal data
Flexible
With wire end
ferrule
Stripping length / contact length: 10 mm
66
Labelling Description
GE GND external supply
24E 24 V external supply through safely separated power supply unit
(SELV/PELV)
IEC 61131−2, 19.2 ... 28.8 V, residual ripple max. ±5 %
Current during operation: 1.4 A
Starting current: 4 A for 100 ms
SB Reserved
Conductor cross−section
2
[mm ]
0.2 ... 2.5
labelling Description
GOI GND digital out/in
DI1 External control of the brake chopper; its only purpose is to
synchronise the brake choppers if a second power supply module is
used.
DO1 without function
DO2 Brake chopper active: HIGH level
DO3 Short circuit of brake chopper,
active: LOW level (fail−safe)
DO4 Overtemperature of heatsink,
active: LOW level (fail−safe)
Conductor cross−section
2
[mm ]
0.2 ... 2.5
l
Tightening torque
[AWG] [Nm]
24 ... 12 Spring terminal
Tightening torque
[AWG] [Nm]
24 ... 12 Spring terminal
[lb−in]
Reset by switching of
24 V at X11.
[lb−in]
EDK94PNE245 DE/EN/FR/ES/IT 4.0