Thermador PROFESSIONAL PRO GRAND PRD364JDGC Manual De Instalación página 10

Installation Clearances with Flush Island Trim
36" (914 mm) min .
to combustible
materials
36¾" (933 mm) Max.
35⅞" (911 mm) Min.
as defined in the "National Fuel Gas Code" (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA. Clearances of less than 12" (305 mm)
must be approved by the local codes and/or by the local authority having jurisdiction.
12" (305 mm) min. to 12" (305 mm) min. to 12" (305 mm) min. to
combustible surface combustible surface combustible surface
with Flush Island Trim with Flush Island Trim with Flush Island Trim
31¼" (794 mm)
29⅛" (740 mm)
25⅛" (638 mm)
max. recess depth
26⅞" (683 mm)
48¾" (1238 mm)
Cantilever
If an inner wall
is used under the
cantilever counter
top, there should be a
⅛" (3 mm) gap from
the rear of the range
to the inner wall.
Figure 3: Installation Clearances with Flush Island Trim
Combustible
Materials
Shaded area behind Shaded area behind Shaded area behind
range indicates range indicates range indicates
minimum clearance minimum clearance minimum clearance
to combustible surfaces, to combustible surfaces, to combustible surfaces,
combustible materials combustible materials combustible materials
cannot be located within cannot be located within cannot be located within
this area. this area. this area.
For Flush Island Trim For Flush Island Trim For Flush Island Trim
installations, counter installations, counter installations, counter
surface should have surface should have surface should have
a cantilever edge a cantilever edge
meeting the back meeting the back meeting the back
section of the Flush section of the Flush section of the Flush
Island Trim accessory. Island Trim accessory. Island Trim accessory.
English 7