Electric Supply - Thermador Professional PRO-GRAND PD36 Serie Instrucciones De Instalación

Step 2: Cabinet Preparation
GAS AND ELECTRIC SUPPLY ZONES:
FIG. 3A Gas & Electrical Supply Zone for Dual Fuel Ranges
Typical placement shown.
Other placement of Gas
Supply and Electrical
Receptacle within the
Electrical and Gas Supply
Zone is acceptable.
Gas
3/4" Flex Line to
Appliance
NOTE:
A Manual Gas
Shut-Off Valve
(not shown)
must be easily
accessible
through an
adjacent cabinet
without moving
the range.
2" Maximum Protru-
sion from Wall for
Gas Supply
Floor
240 VAC Receptacle
(Shown) or Junction
Centerline of
Electrical
Zone
Model A B C D E
PD30 8" 12" 10" 6-1/2" 5-1/4"
PD36 10-1/2" 15" 10-1/2" 6-1/2" 5-1/4"
PD48 16-1/2" 16" 15-1/2" 6-1/2" 5-1/4"
The Dual Fuel ranges may be con-
nected to the power supply with a
range supply cord kit or by hard-
wiring to the power supply. It is the
responsibility of the installer to pro-
vide the proper wiring components
(cord or conduit and wires) and com-
plete the electrical connection as dic-
tated by local codes and ordinances,
and/or the National Electric Code.
The units must be properly grounded.
Refer to Step 6 for details.
The range must be connected only
to the type of gas for which it is
certified. If the range is to be con-
nected to propane gas, ensu re that the
propane gas supply tank is equipped
with its own high pressure regulator in
addition to the pressure regulator sup-
plied with the range. (See STEP 5.)
NOTE: Any opening in the wall behind the appliance and
any opening in the floor under the appliance must be
sealed.