Video Connections; Connecting To The Hdmi Terminal; Selecting The Priority Video Output When Connecting Hdmi And Component Video - Pioneer BDP-120 Manual De Instrucciones

Video Connections

Connecting to the HDMI Terminal

• You can enjoy high quality digital picture and sound through the HDMI terminal.
• See page 45 for information on the output of next generation audio formats.
• Use High Speed HDMI™ cables when using the KURO LINK function. The KURO LINK function may not
operate properly if other HDMI cables are used.
STEPS
1 Be sure to turn off this Player and the equipment before making any connections.
Firmly connect an HDMI cable (commercially available) to the HDMI terminals (1 and 2).
2
• When using an HDMI output, 7.1 ch
Digital Output is available.
Video signal outputs:
1080p 24 Hz 720p 50/60 Hz
1080p 50/60 Hz 576p 50 Hz
1080i 50/60 Hz 480p 60 Hz
For example;
1080p: 1080 progressive scan
1080i: 1080 interlace scan
1
To HDMI OUT terminal
2
To HDMI IN terminal
After connecting
• Secure the HDMI cable to the HDMI cable holder, passing it through the holder. (Page 11)
• If desired, connect audio equipment. (Page 17)
• Load a disc and start playback. (Pages 24–29)
• Refer to KURO LINK function. (Pages 23 and 38)
14
This Player
HDMI cable
(commercially available)
Projector TV
Equipment with an HDMI terminal
• Audio transmitted in DTS-HD High
Resolution Audio and DTS-HD Master
Audio formats is output from the
HDMI terminal as Bitstream. Connect
an amplifier with a built-in decoder to
enjoy the fine sound quality.
Selecting the priority video output when
connecting HDMI and Component video
When you connect both an HDMI cable and a
component cable to this player, you need to select
the priority video output in "Settings" – "Audio Video
Settings" – "Video Out Select". (See page 37.)
NOTE
• When you connect the player to a Pioneer TV with an
HDMI cable only and the TV is turned on, the video output
switches to HDMI automatically. (The above setting is
unnecessary.)
• When you connect the player to a TV with an HDMI cable,
"HDMI Video Out" is set to "Auto". If you don't get a stable
image, select the desired resolution*.
When you set "HDMI Video Out" to a setting other than
"Auto", you can only select resolutions* that are compatible
with the connected TV.
* Refer to "HDMI Video Out" on page 37 regarding the
resolutions of the HDMI video output.
AV receiver
NOTE