Troubleshooting - Dometic TEC29EV Instrucciones De Uso

TEC29EV
11

Troubleshooting

Fault Cause
The remote con- Starter battery is flat.
trol does not
Power cable is disconnected or the
come on when
plug is removed.
the on/off switch
is pressed.
Generator earth cable is discon-
nected or the fuse (if available) is
blown.
The starter does Starter battery is flat.
not work when
The main switch is at "0".
the start button is
pressed.
Starter shaft is dirty.
Too much oil in the engine.
Inverter is damaged.
Power cable is disconnected or the
plug is removed.
Generator earth cable is discon-
nected or the fuse (if available) is
blown.
Starter is not receiving any power.
The starter turns No petrol/LPG.
but the genera-
Spark plug is not receiving any power. ➤ Check the electric connec-
tor does not start.
Carburettor is not receiving any pet-
rol.
Air intake is blocked.
The ambient temperature is below
0 °C.
Inverter is damaged.
Power cable is disconnected or the
plug is removed.
EN
Troubleshooting
Remedy
➤ Charge the starter battery.
➤ Contact an authorised work-
shop.
➤ Charge the starter battery.
➤ Set the main switch to "I" or
"1".
➤ Clean the starter shaft.
➤ Drain the oil.
➤ Contact an authorised work-
shop.
➤ Fill up with petrol/LPG.
tions.
➤ Clean the carburettor.
➤ Check the air filter (see chap-
ter "Servicing the air filter
(fig. 7, page 6)" on page 25).
➤ Use pure propane gas.
➤ Contact an authorised work-
shop.
27