Troubleshooting Information - Dometic ENERGY & LIGHTING TEC Serie Instrucciones De Montaje Y De Uso

TROUBLESHOOTING INFORMATION

FINDING MALFUNCTIONS
The aim of the following information is to
help identify and correct any malfunctions
and problems that might occur during
use. Some of these problems may be
solved by the user, while for all the others
Problem
When the starter button is
pressed the control panel does
not light up
When the starter button is
pressed the unit does not start
The starter motor turns, but the
unit does not start
The unit tends to shut down
All manuals and user guides at all-guides.com
specific technical knowledge or abilities
are required, so that they must only be
carried out by qualified technicians of
proven experience in the specific field of
operation.
Cause
The power cables are
disconnected or they do not
provide a continuous supply
Safety switch in pos. 0
Main fuse damaged
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
The starter motor does not turn
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
Malfunction in the pump power
supply
Engine malfunction
Injectors dirty or faulty
Cooling air/water pipe blocked
Fuel level too low
Sea water pump rotor worn
The inverter is broken
Malfunction in the pump power
supply
Injectors dirty or faulty
Air filter blocked
Cooling air/water pipe blocked
Fuel level too low
- -
31
Remedy
Contact the service department
Press safety switch in order to enable the
power supply of the equipment.
Replace fuse (See
"Replacement of fuses")
Change the battery
Contact the service department
Contact the service department
Contact the service department
Change the battery
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Contact the service department
Check the cooling air/water pipe
and clean it if necessary
Replace the rotor (see "Changing
the water pump rotor")
Contact the service department
Contact the service department
Contact the service department
Clean the air filter
Check the cooling air/water pipe
and clean it if necessary
Fill up with fuel
GB
User Manual