TEC29EV
10.2
Preparing maintenance work
!
CAUTION!
Note the following for all maintenance work:
The generator must not be running.
All the parts must be cooled down.
➤ Switch the generator to no function with the main switch (fig. 4 1,
page 4).
➤ Disconnect the positive terminal of the supply battery.
➤ Open the generator front door.
For maintenance work, you can take the generator out (fig. 5, page 5):
!
WARNING!
The mounting plate with generator is very heavy (> 40 kg) and
could fall out the housing if you take it out too far.
➤ Undo the fastening screws (1).
➤ Remove the mounting plate (2) with the generator from the housing (3).
10.3
Finishing maintenance work
➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. 4 1, page 4).
➤ Close the generator front door.
EN
Servicing the generator
23