Troubleshooting - Dometic TEC29 Instrucciones De Uso

TEC29, TEC29LPG
11

Troubleshooting

Fault Cause
The control panel Starter battery is flat.
does not come
Power cable is disconnected or the
on when the
plug is removed.
on/off switch is
Generator earth cable is discon-
pressed.
nected or the fuse (if available) is
blown.
The starter does Starter battery is flat.
not work when
The main switch is at "0".
the start button is
pressed.
Starter shaft is dirty.
Too much oil in the engine.
Inverter is damaged.
Power cable is disconnected or the
plug is removed.
Generator earth cable is discon-
nected or the fuse (if available) is
blown.
Starter is not receiving any power.
The starter turns No petrol.
but the genera-
Spark plug is not receiving any power. ➤ Check the electric connec-
tor does not start.
Carburettor is not receiving any pet-
rol.
Air intake is blocked.
Inverter is damaged.
Power cable is disconnected or the
plug is removed.
The generator Too much oil in the engine.
tends to go off.
Load is over 2.6 kW.
Carburettor is not receiving any pet-
rol.
Air intake is blocked.
Inverter is damaged.
Electromagnet (inverter) is blocked.
Air filter is dirty.
EN
Troubleshooting
Remedy
➤ Charge the starter battery.
➤ Contact an authorised work-
shop.
➤ Charge the starter battery.
➤ Set the main switch to "I" or
"1".
➤ Clean the starter shaft.
➤ Drain the oil.
➤ Contact an authorised work-
shop.
➤ Fill up with petrol.
tions.
➤ Clean the carburettor.
➤ Check the air filter (see "Ser-
vicing the air filter (fig. 7,
page 5)" on page 49).
➤ Contact an authorised work-
shop.
➤ Drain the oil.
➤ Switch off the consumers.
➤ Clean the carburettor.
➤ Check the air filter (see "Ser-
vicing the air filter (fig. 7,
page 5)" on page 49).
➤ Contact an authorised work-
shop.
51