Cleaning And Maintenance; Troubleshooting; Support - Franke FMY 45 MW XS Manual De Usuario

Horno microondas combi compacto
Ocultar thumbs Ver también para FMY 45 MW XS:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48

CLEANING AND MAINTENANCE

Make sure that the appliance has cooled down
before carrying out any maintenance or cleaning.
Do not use steam cleaners.
INTERIOR AND EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth�
If they are very dirty, add a few drops of pH-neutral
detergent� Finish off with a dry cloth�
• Clean the door glass with a suitable liquid detergent�
• At regular intervals or in case of spills, remove the
turntable and its support to clean the bottom of the
oven, removing all food residue�
• The grill does not need to be cleaned as the intense
heat burns away any dirt: Use this function on a
regular basis�

TROUBLESHOOTING

Problem
The oven is not working�
The oven makes noises, even
when it is switched off�
The display shows the letter
"ERR" followed by a number�

SUPPORT

In the event of any operation problems, contact a Franke
Technical Service Centre�
Never use the services of unauthorized technicians�
Specify:
- the type of fault
- the appliance model (art�/Code)
- the serial number (S�N�) on the rating plate, located
on the right hand edge of the oven cavity (visible
when the oven door is open)�
001
Do not use wire wool, abrasive scourers or abrasive/
corrosive cleaning agents, as these could damage
the surfaces of the appliance.
ACCESSORIES
All accessories are dishwasher safe�
For stubborn dirt, rub gently with a cloth� Always
leave the accessories to cool down before cleaning�
Possible cause
Power cut.
Disconnection from the
mains.
Cooling fan active.
Software fault.
When contacting our
Service Centre, please
state the codes provided
on your product's
identification plate�
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the
electricity supply. Turn off the oven and restart it to
see if the fault persists.
Open the door or wait until the cooling process has
finished.
Contact you nearest Client After-sales Service
Centre and state the number following the letter
"ERR".
EN
XXX/XXX
XXXXXXXXXXXX
XXXXXXXXXXXX
13

Publicidad

Tabla de contenido
loading

Tabla de contenido