Battery Information; Care And Cleaning - Bright Starts Rock and Swing 2-in-1 Jungle Stream Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery Information

The swing control module requires (4) size C/LR14 (1.5V) alkaline batteries (not included) without AC Adapter. When using the
AC adapter, only use the one supplied with this swing. Do not use extension cords. Check the AC adapter, including the plug and
cord, regularly for damage. Do not use if any damage has occurred.
CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be
shortened or the batteries may leak or rupture.
• Always keep batteries away from children.
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked "rechargeable. "
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not use rechargeable alkaline batteries in a Ni-Cad or Ni-MH battery charger.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the swing into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or
non-working motorized parts. Because each electrical component requires a different operating voltage, replace the
batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.
This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances
that can be damaging to the environment and health. Contact local authority for recycling & collection information.

Care and Cleaning

• Seat pad and headrest– Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop
patches to the corresponding patch.
• Headrest- Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toy bar and toys– Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
FCC Statement / CAN ICES-3 (B) / NMB-3(B)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
– 3 –

Publicidad

Tabla de contenido
loading

Tabla de contenido