Dyna-Glo DGP483SSN Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS
11. Pre-assemble two M6x16 bolts (AA) onto the
cart right side panel assembly (L) and do not
tighten them. Make sure to leave a 5mm gap
between the bolt and the panel. Hang the
natural gas hose bracket onto the bolts and
tighten the two bolts. Put the two-piece natural
gas hose holders (A2) on the hose. Attach the
natural gas hose (A2) to the bottom shelf (A1)
with two M4x12 bolts (BB). NOTE: Make sure
the natural gas hose exits through the hole in
the cart rear panel (Z).
Hardware Used
AA
M6x16 Bolt
BB M4x12 Bolt
12. Insert two M6x16 bolts (AA) in left side of grill
body (C) as shown, leaving 5mm of threads
exposed. Align key hole in left side table
assembly (V) with the two bolts just inserted in
the grill body (C), and insert two M6x16 bolts
(AA) in the remaining holes in the grill body (C).
Adjust left side table assembly (V) correctly,
then tighten all bolts.
Hardware Used
AA
M6x16 Bolt
11
A1
x 2
x 2
12
V
x 4
12
AA
L
A2
Z
A2
A2
C
AA
5mm
BB