Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN 1491 Operación Manual

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 70
• Operating Instructions
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

12.3 Unpacking

To unpack the device, remove the device out of the carton and remove the packaging
material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

12.5 Setup

12.5.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the device and the maximum weight of the
expected food that is to be prepared in the oven.
• Choose the setup location in such a way that children cannot reach any hot surfaces
on the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the device.
• Do not cover up any openings on the device and do not block these off.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
31

Publicidad

Tabla de contenido
loading

Tabla de contenido