Adjusting The Camera Direction And Coverage - Sony IPELA SNC-DF40N Manual De Instalación

Ocultar thumbs Ver también para IPELA SNC-DF40N:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Notes
• Be sure to install the supplied wire rope to
the camera and the ceiling or wall.
• If you cannot use screws on a ceiling or
wall, or if you want to hide the camera to
be less conspicuous, use the YT-ICB40 in-
ceiling bracket (optional) with which you
can mount the camera on the ceiling.
• If the ceiling or wall material is not strong
enough to hold the screws, the camera may
fall off. Reinforce the ceiling or wall as
needed.
14
GB
Installing the Unit
2 Adjusting the Camera
Direction and Coverage
4
5
1
Loosen the tilt angle adjustment
screw.
The tilt angle adjustment screw is
located on the side of the angle adjuster
bracket. Loosen the screw with a
Phillips screwdriver before adjusting the
lens position.
2
Turn the lens in the desired direction.
You can adjust the lens position by
panning
A
, tilting
3
When you have set the lens in the
desired direction, tighten the tilt angle
adjustment screw to fix the lens
position.
4
Loosen the zoom lever and move it to
the right or left to adjust the field of
view.
When you have set the zoom lever to the
desired position, tighten it to fix the field
of view.
5
Loosen the focus lever and move it to
the right or left to adjust the focus.
When you have set the
desired position, tighten it to fix the
focus
.
6
Repeat steps 1 to 5 until the camera
direction and coverage are
determined.
1, 3
B
, or rotating
C
.
focus
lever to the

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ipela snc-df40p

Tabla de contenido