Manually Interrupting The Boiling Cycle; Pouring Water; Cleaning And Care; Cleaning The Water Kettle - Silvercrest SWKG 2000 B1 Instrucciones De Utilización Y De Seguridad

automatically used empty or with an insufficient
amount of water.
If the overheat protection is triggered, proceed as
follows:
Unplug from the protective ground socket and
allow the device to cool to room temperature.
Once cooled, it can be used again.
Manually interrupting
the boiling cycle
Slide the ON / OFF switch
"0" position.

Pouring water

Remove the water reservoir
station to pour.
4
Opening the safety lid
Pour the hot water through the pouring spout
into the designated vessel. Before boiling again,
allow the device to first cool to room temperature.

Cleaning and Care

Always unplug from the mains before
cleaning and allow the device to cool
completely before cleaning and storing!
Never immerse the base station and
water reservoir in water. This poses a
risk of burns or electric shock!
Do not use caustic cleaners and abra-
sives or scouring pads, as this may cause
damage the device beyond repair.

Cleaning the water kettle

Clean all exterior surfaces and the mains cable
with a slightly dampened dishcloth. Always dry
the device well before using it again. For stub-
born soiling use a mild detergent on the cloth.
upward to the
3
from the base
5
is not required.
8
7
Start-up / Cleaning and Care
Ensure there is no washing-up liquid residue on
and inside the device before using it again.
Rinse the inside of the water reservoir
clean water.
Remove deposits inside the water reservoir
by wiping the inside surface with a damp cloth,
or use a washing-up or bottle brush. Then rinse
the water reservoir

Cleaning the filter cartridge

The filter cartridge is removable for enhanced
cleaning.
Remove the filter cartridge upward at the re-
lease tab.
Clean the filter cartridge with some citric acid or
lime dissolver suitable for food containers from
a homeware shop (e.g. coffee maker cleaner).
Rinse the filter cartridge well with water.
Please carefully slide the filter cartridge down-
ward along the designated guide groove.

Descaling the glass kettle

Note: Severely scaled devices can result in the de-
vice automatically switching off early and energy loss.
Therefore regularly descale the glass kettle (varies
by lime content in the water and frequency of use).
Only use citric acid or lime dissolver suitable for food
containers from a houseware shop (e.g. coffee maker
cleaner), do not use acetic acid or other acids.
Fill the water reservoir
to a simmer.
Add some citric acid or lime dissolver suitable
for food containers from a housewares shop
(e.g. coffee maker cleaner).
Unplug from the protective ground socket. Lime-
scale will dissolve as the water cools.
Occasionally swivel the water reservoir
Repeat the process for thick layers of limescale.
Note: Descaling may be interrupted, even if
some limescale remains. Descaling down to the
bare metal surface is not required.
After descaling, simmer 2–3 fillings of fresh water
and discard the water.
with
5
with clean water again.
5
with water and heat
5
.
5
GB/MT
5
31