Boiling water
♦
Lift the jug
♦
Open the lid
♦
Fill the kettle
spill out. When filling, hold the jug
scale
♦
Close the lid
♦
Place the filled jug
♦
Insert the plug into a mains power socket. The
the current temperature of the water contained in the jug is then shown on
the display
♦
Press the
flashes,
during the heating process.
♦
As soon as the water reaches the set temperature, you will hear a beep and
the heating process will stops. The display indicator
out after about 30 seconds.
WARNING – RISK OF INJURY!
►
Do not open the lid
There is a risk of scalding.
NOTE
►
You can stop the heating process at any time by pressing the
or removing the jug from the
buttons go out.
►
When you replace the jug
be resumed until you press the
Heating the water to a specific temperature
The appliance has a setting allowing you to specify your desired water temper-
ature. You can set the target temperature between 40°C and 100°C in 5°C
stages.
♦
If the appliance is deactivated, press the
ture of the water contained in the jug is then shown in the display
♦
Press one of the arrow keys
The heating process starts automatically. You can also change the tempera-
ture during the heating process.
♦
As soon as the water reaches the set temperature, you will hear a beep and
the heating process will stops. The display indicator
out after about 30 seconds.
■
26
│ GB│IE
off the base
to fill it with water.
by pressing the release button
no further than the MAX mark, so that boiling water cannot
correctly.
by pushing it down until it clicks into place.
onto the base
.
button
to start the heating process. The display indicator
(°C) is displayed by default. The
while the water is boiling or extremely hot.
on the base
.
upright. This allows you to read the
.
button
button
base
. The display indicator
, the heating process will not
button
again.
button
to choose the desired target temperature.
lights up and
will light up
and all buttons go
button
and all
. The current tempera-
.
and all buttons go
SWKD 2400 B2