Maintenance / Recommendations; Periodical Maintenance - GYS Easymig 130 Manual De Instrucciones

Translation of the original instructions
e. Earthing of the welded part : When the part is not earthed because for electrical safety reasons or because
of its size and its location (which is the case with ship hulls or metallic building structures), the earthing of
the part can, in some cases but not systematically, reduce emissions. It is preferable to avoid the earthing of
parts that could increase the risk of injury to the users or damage other electrical equipments. If necessary,
it is appropriate that the earthing of the part is done directly, but in some countries that do not allow such a
direct connection, it is appropriate that the connection is made with a capacitor selected according to national
regulations.
f. Protection and plating : The selective protection and plating of other cables and devices in the area can
reduce perturbation issues. The protection of the entire welding area can be considered for specific situations.
TRANSPORT AND TRANSIT OF THE MACHINE
The machine is equipped with handles. Be careful not to underestimate the machine's weight.
Do not use the cables or torches to move the machine. It must be moved in a vertical position.
Transportation standards are different.
Never lift the machine on top of persons or objects.
INSTALLATION
These machines can work in difficult environments. However it is essential to follow the instructions listed below :
• Put the machine on a floor with a maximum inclination of 10°.
• Provide adequate space for the machine's ventilation and easy access to the controls.
• The machine must be protected form the heavy rain and the sun's rays .
• The machine must not be used in an area with metal dusts.
• The machine protection level is IP21, which means :
- Protection against acess to dangerous parts from solid bodies of a ≥12.5mm diameter and,
- Protection against vertically falling drops.
The manufacturer does not accept responsilbity for damage resulting from incorrect and/or
dangerous use of the machine .

MAINTENANCE / RECOMMENDATIONS

• Maintenance should only be carried out by a qualified person.
• Ensure the machine is unplugged, and that the ventilator inside has stopped before
carrying out maintenance work. DANGER High Voltage and Currents inside the machine.

Periodical maintenance:

• Periodically remove the cover and dust with an air gun. You are advised to have the electrical connections
checked by a qualified person, with an insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it must be replaced
by the manufacturer, an after sales service or a qualified person to prevent danger.
• Do not obstruct the machine's air intake, to allow air circulation.
• Check that the torch does not have any cracks or exposed wires.
• Check that the consumables are installed properly and not worn .
• Do not use this equipment to thaw pipes, to charge batteries, or to start any engine.
16
EASYMIG 130 / 140 / 150
EN