Software Installation - Conceptronic 128CC Guia De Inicio Rapido

ENGLISH
Congratulations on the purchase of your Conceptronic 128CC.
The enclosed Hardware Installation Guide gives you a step by step explanation of how to install the
C128CC on your Notebook/PC. When problems occur, we advise you to go to our support-site
(go to www.conceptronic.com
solve your problems.
In order to provide the requested support we need the following details from you:
•
A clear description of the problem;
•
Version number of the drivers you are using (always check the Conceptronic website to see
wether you are using the latest version);
•
Type of Notebook/PC you are using;
•
Operating system you are using
For more information about Conceptronic products, please visit the Conceptronic Web Site:
www.conceptronic.com
The Software installation as described below, may be slightly different from the installation on your
computer. This depends on the Windows version you are using.

1. Software installation

Precautions for software installation under Windows95 /98(SE)/2000/XP
1. This quick installation guide aims at helping you to setup the ISDA TA PC Card and go to the
Internet in VCOMM mode with ease and efficiency. For NDIS and CAPI modes, refer to the
user manual for details.
2. Do NOT insert the PCMCIA card until after the software installation is completed.
3. Before you proceed the following steps, make sure no old driver suites exist in your computer.
Uninstall any old driver suites that already exist, for these could hamper your computer sys-
tem.
1.1 Software installation for Windows 95/98(SE) and ME
1. Go to My Computer.
2. Select the CDROM drive which contains driver CD-ROM. and double-click on folder
'D:\win9xme', (assuming that D:\ is your CD ROM drive)
3. Double-click 'setup.exe'. Click 'Next'.
Conceptronic 128CC
Quick Start Guide
and click 'support/2-Tech'). Here you will find a lot of possibilities to
- 6 -