Conceptronic 128CC Guia De Inicio Rapido página 8

ENGLISH
1.3 Software installation for Windows NT
Precautions for software installation under Windows NT:
1. This quick installation guide aims at helping you to setup the ISDA TA PC Card and go to the
Internet in NDIS mode with ease and efficiency. For CAPI mode, please refer to the user
manual for details.
2. Before you proceed the following steps, make sure no old driver suites exist in your computer.
Uninstall any old driver suites that already exist, for these could hamper your computer sys-
tem.
Installation
1. Go to: Start-> Settings-> Control Panel.
2. Select 'Network'. A Network dialog box will appear. Select 'Adapter Tab'. Click 'Add...'.
3. Click 'Have Disk...' and click 'Ok' to continue.
4. If you are using disks to install the device driver, insert the disk into your free floppy drive and
type in the drive name, for example, 'A:', to continue. Or if you are using compact disk to in-
stall, insert the compact disk into your computer and type in the CD-ROM drive letter followed
by '\winnt\driver', and click 'Ok' to continue.
5. When the 'Select OEM Option' dialog box appears, click 'Ok' to continue.
6. The following dialog box will prompt you to change the I/O and IRQ settings. You may refer to
the Hardware Detection to know the available addresses to avoid any conflicts with your sys-
tem. (Go to: Start-> Programs -> Select 'Configuration Utility'. Open 'Hardware Detection'.)
7. Press 'OK' to continue. The installation program will proceed automatically.
8. When finished, a 'Setup Message' will prompt you to invoke 'Remote Access Services (RAS)'
setup. Press 'OK' to continue.
9. When the 'Network' dialog box appears, select the 'Services' tab.
10. Select 'Remote Access Service'. Click 'Properties'. The following figure will appear. Select
'Add...' When the 'Add RAS Device' dialog box appears, select 'ISDN1 – ISDN_TA' and click
'Ok'. Press 'Add...' again to add 'ISDN2-ISDN_TA'. When completed, press 'Continue'. You
- 8 -