Conceptronic 128CC Guia De Inicio Rapido página 7

ENGLISH
4. Keep the default location. Click 'Next'. Keep the default 'Program Folder', click 'Next'.
5. Click 'Next', to install the program.
6. Click 'Finish' to complete and to restart your computer. I n sert the PCMCIA card into your
PCMCIA socket, when Windows has start up.
7. The drivers for the card are installed automatic by Windows for Windows 95/ 98(SE) and ME
after the restart.
8. During or after the driver installation, a Wizard 'ISDN Configuration' will appear. Please make
the following settings. Click 'Next'.
9. Select 'DSS1: Euro ISDN' as switch protocol. Click 'Next'
10. Skip the phone number settings, click Next.
11. Click 'Finish' to complete.
12. Windows 2000 will prompt a message about the digital signature, click 'Yes' to proceed. Fol-
low the instructions on the screen to complete the installation.
After your computer is restarted and the PCMCIA card is installed, an icon is added in your system
tray and will be prompted on the bottom right of your screen, i.e. Line Status and Dialer, which
means the device driver has been installed successfully.
1.2 Software installation for Windows 2000 and XP
1. Go to My Computer.
2. Select the CDROM drive which contains driver CD-ROM. and double-click on folder
'D:\w2kxp', (assuming that D:\ is your CD ROM drive)
3. Double-click 'setup.exe'. Click 'Next'.
4. Keep the default location. Click 'Next'. Keep the default 'Pr ogram Folder', click 'Next'.
5. Click 'Next', to install the program.
6. Click 'Finish' to complete and to restart your computer. I n sert the PCMCIA card into your
PCMCIA socket, when Windows has start up.
7. Windows XP will prompt you, that new hardware is found. Select 'Automatically find drivers',
click Next. When the message appears about the 'Windows logo test', click' Continue Any-
way'. This message appears a several times, repeat this step. Follow the instructions on the
screen to complete the installation.
8. For Windows 2000 and XP: During or after the driver installation, a Wizard 'ISDN Configura-
tion' will appear. Select; 'Europe ISDN (DSS1)', click 'Next'.
9. Skip the phone number setting, by clicking 'Next'.
10. Click 'Finish' to complete and to restart your computer.
After your computer is restarted and the PCMCIA card is installed, an icon is added in your system
tray and will be prompted on the bottom right of your screen, i.e. Line Status and Dialer, which
means the device driver has been installed successfully.
- 7 -