To Install - Leviton 57000 Serie Instrucciones De Instalación

WARNING:
THIS DEVICE IS NOT A LIGHTNING ARRESTOR. IT WILL NOT
SURVIVE LIGHTNING STRIKES IN CLOSE PROXIMITY TO THE PREMISES
OR SUSTAINED OVERVOLTAGES.
WARNING:
ELECTROCUTION AND FATAL OR SERIOUS INJURY AND
PROPERTY DAMAGE CAN RESULT FROM FAULTY INSTALLATION.
OTHER CAUTIONS AND NOTES:
1. USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE.
WITH ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR
CU/AL.
2.
DO NOT OPERATE AT ALTITUDES EXCEEDING 2000 METERS.
3.
OPERATE INDOORS BETWEEN 30-90% RELATIVE HUMIDITY.
4.
IT IS RECOMMENDED THAT THE 57000 TVSS PANEL PROTECTION
SYSTEM BE INSTALLED BY A QUALIFIED ELECTRICIAN.

TO INSTALL:

WARNING:
1. TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER
AT CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS OFF
BEFORE WIRING!
2. Identify the device or load to be protected: The 57000 Panel should
be located as close as possible to the electrical panel serving the load to
be protected in order to minimize connection lead length resistance and
inductance.
L1
L2
V(L-N)
L3
N
G
Fig. 1 - Three Phase, 4 Wire with Ground, WYE
V(L-N) V(L-L)
V(L-N)
G N L1
TVSS
Module 3
Common
Mode Module
Module 2
L2 L3
Module 1
Page 2