Remote Connection - Leviton 57000 Serie Instrucciones De Instalación

Table 1 - Diagnostic Indicator Functions:
List of the diagnostic functions of the 57000 series
panels.
Mode Fault Beeper
LED
(Red)
Normal
OFF OFF
OFF OFF
Module ON ON
Fault
ON OFF
Low ON ON
Battery
OFF OFF
No AC
ON ON
Power
ON OFF
OFF OFF
Self
ON ON
Test
The ground terminal within the TVSS Panel is connected to the metal
enclosure. For isolated ground systems, the isolated ground wire should not
be connected to the In-Out ground terminals. However, as indicated in step
5, the enclosure must be grounded via a ground conductor to the ground
terminal. With the power OFF, connect phase leads to L1, L2, and L3
without regard to phase A, B, or C. Connect the neutral, for WYE systems,
to the neutral terminal. Connect ground to ground terminal. Figs. 4 and 5
illustrate alternate connection systems which use circuit breakers (either
dedicated or load sharing), or a disconnect switch. Connection leads should
be cut to length and wrapped. Avoid sharp bends. Lead wire insulation
should not be cut or damaged except to expose ends for connection.

8. Remote connection:

• Relay status circuit and contacts rated at 5 Amps. The voltage rating is
250VAC/30VDC. Contacts accommodate 20-12 AWG wire secured to
terminals using 3.5 in.-lbs. of torque. Wiring must be rated 600 VAC,
dressed and secured away from live parts and protected from sharp
edges and door entrapment. Hole must be cut in enclosure for conduit
connection. If surge protection fails, continuity will be between the "NO"
and "C" contacts.
NOTE: If surge suppression failure has occurred, a transient surge
has exceeded the rating of the module and it should be replaced
immediately.
Page 7
Remote Module Battery
LEDs Status
(Green) LED
(Yellow)
OFF ON OFF
OFF ON OFF
ON OFF
one or more
ON OFF OFF
ON ON ON
OFF ON ON
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON ON ON
Beeper
Battery Disable
("Low Battery")
("Audio Alarm")
Disable Disable Disable Disable
Button LED Button
OUT OFF OUT
IN ON OUT
OUT OFF OUT
IN ON OUT
OUT OFF OUT
OUT OFF IN
OUT OFF OUT
IN OFF OUT
OUT OFF IN
OUT OFF OUT
Self Test
("Test")
Momentary
LED Action
Button
OFF OUT
OFF OUT
OFF OUT
OFF OUT
OFF OUT
ON OUT
OFF OUT
OFF OUT
OFF OUT
OFF IN