Flush Mount Side Trim Installation; Installation - AGA marvel MP30RA2 Instrucciones De Instalación

Flush Mount Side Trim Installation

Note: If the unit is to be installed flush with the cabinets, the flush mount side trim must be
installed first. If not, skip to "installation".
Step 1 - Locate the necessary parts: Two (2) flush mount trim pieces and a hardware kit with
twenty-two (22) screws.
Step 2 - Remove the side trim on the refrigerator and discard the trim and screws.
Step 3 - Align the top of the flush mount side trim with the top of the unit's machine
compartment. Using the screws included in the hardware kit, attach the side trim to the unit,
only using the holes visible through the side trim. Note: Do not use the screw holes in the
machine compartment.

Installation

1
Place unit in front of cutout.
3
Using an 8" magnetic nut driver, remove
the two 1/4" screws.
2
Pull the center grille louver up
at an angle and pull out.
4
Remove grille assembly.
35