Unit Description; Initial Use - Beurer IL 35 Instrucciones Para El Uso

Lampara a raggi infrarossi
Ocultar thumbs Ver también para IL 35:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
General notes
Important
• Product is not suitable for lighting rooms in private homes.
• This unit is not intended for commercial or clinical use, but only for individual, private household use!
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• Lighting is excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

1
6
5
3
4

5. Initial use

Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
Replacing the fuse (UK plug only)
If the fuse needs replacing, please observe the following:
• Remove the mains plug.
• Lift out the fuse holder from the inside of the mains plug using a flat screwdriver.
• Pull out the fuse from the fuse holder and replace it with a new fuse type: 3A (breaking capacity 6 kA at 240 V)
in accordance with BS-1362 / SS167.
• Press the fuse holder containing the new fuse into the plug slot.
• Plug the mains plug into the socket and test to see if it works.
1. Light source
2
2. Lamp shade
3. Base
4. On/Off button + timer button
5. LED timer indication
6. First LED = readiness indicator/standby
9

Publicidad

Tabla de contenido
loading

Tabla de contenido