Homelite HLT26CDB Manual De Utilización página 27

For technical review, sent 3 Dec 2013.
are properly and securely attached.
Use only the manufacturer's replacement line in the
cutting head. Do not use any other cutting attachment.
Never operate unit without the safety guard in place
and in good condition.
Maintain a firm grip on both handles while trimming.
Keep bump head below waist level. Never cut with
the bump head located over 76 cm or more above the
ground.
SPECIFICATIONS
Weight
- Without fuel, cutting
attachment and harness
- Without fuel with bump
head
Fuel tank volume
Cutting swath
Engine displacement
Line diameter
Maximum engine
performance (in
accordance with ISO
8893)
Maximum rotational
frequency of the the
spindle
Engine speed
(rotational frequency)
at recommended max.
spindle rotational
frequency
Engine speed (rotational
frequency) at idle
Fuel consumption (in
accordance with ISO
8893) at max. engine
performance
consumption (in
accordance with ISO
8893) at max. engine
performance
DESCRIPTION
English (Original instructions)
HLT26CDB HLT26CDSB
4,06 4,39
4,27 4,60
3 3
250cm or 250cm or
(0,25L) (0,25L)
432 mm 432 mm
3 3
26 cm /cc 26 cm /cc
2,0 mm 2,0 mm
0,65 kW 0,65 kW
-1 -1
12000 min 12000 min
-1 -1
12000 min 12000 min
2800 - 3800 2800 - 3800
-1 -1
min min
0,33kg/h or 0,33kg/h or
(0,45 L/h) (0,45 L/h)
508 g/kW.h 508 g/kW.h
or (0,7 L/ or (0,7 L/
kW.h) kW.h)
Please refer to Fig. 1.
1. Primer Bulb
2. Choke lever
3. Fuel Cap
4. Starter Grip
5. Throttle Lock
6. On / Off Switch
7. Throttle Trigger
8. Rear Handle
9. Front handle
10. Shaft
11. Safety Guard
12. Bump Head
13. Cutting Line
14. Idle Speed Screw
15. Knob (HLT26CDSB only)
16. Bolt
17. Wing nut
18. Flat washer
19. Wrench
20. Paper tube
21. Hex nut
22. Button (HLT26CDSB only)
23. Guide recess (HLT26CDSB only)
24. Coupler (HLT26CDSB only)
25. Spool retainer
26. Trimmer attachment (HLT26CDSB only)
ASSEMBLY
Please refer to Fig. 2.
UNPACKING
This product requires assembly
Carefully remove the tool and any accessories from
the box.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
WARNING
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
12
.