Calibrating The Sensor Automatically; Calibrating The Sensor Manually; Indiglo Night-Light/Night-Mode Feature; Battery - Timex HEALTH TRACKER Guia Del Usuario

TIp: If goal is set to be measured in distance, step equivalent is automatically calculated using personal
settings. If goal is set to be measured in steps, distance equivalent is automatically calculated.

Calibrating the SenSor aUtomatiCally

Calibrate the sensor for more accurate pace and distance calculations.
1. Press MODE to select SETUP.
2. Press START/STOP/RESET/- to select STRIDE SETUP.
3. Press and hold SET until values to edit flash.
4. Press + and - to select AUTOMATIC. Press NEXT.
5. Press + and - to select WALK or RUN.
6. Press NEXT and + / - to set thousands digit of CAL. LENGTH (this is the distance to walk or run to calibrate).
7. Continue pressing NEXT and + / - to set remaining digits. Press NEXT when finished.
8. When prompted, hold START.
9. When prompted, walk or run selected distance.
10. When distance is reached, press STOP.
If CALIBRATION OKAY displays, setup is complete. If CALIBRATION FAILED displays, repeat calibration.
TIp: Longer distances make more accurate calibrations than shorter ones. The default distance is the distance
of a football field from end zone to end zone (300 ft or 91m).

Calibrating the SenSor manUally

1. If you know your stride length, you can enter the exact measurement without running automatic
calibration. Calibrating the sensor to your precise stride length will result in the most accurate distance
calculations from Health Tracker
2. Press START/STOP/RESET/- to select STRIDE SETUP.
3. Press and hold SET until values to edit flash.
4. Press + and - to select MANUAL.
5. Press + / - and NEXT to set stride length in feet (meters) and inches (centimeters).
6. Press DONE to save settings and exit.
indiglo night-light/night-mode
®
1. Press INDIGLO button to activate night-light for several seconds.
®
2. Hold INDIGLO button for 4 seconds to activate NIGHT-MODE
®
3. In NIGHT-MODE ® feature, press any button to activate night-light.
4. Hold INDIGLO button for 4 seconds to turn off NIGHT-MODE
®
feature automatically turns off after 8 hours.

baTTeRY

Battery type is on watch back. Battery life may vary depending on actual usage.
1. Rotate battery hatch counter-clockwise, following OPEN
arrow. Remove battery hatch (use a coin if battery hatch is
difficult to remove).
2. Rotate plastic cover counter-clockwise until OPEN
points toward top of watch. Remove plastic cover. Remove
battery.
3. Insert new battery.
4. Replace plastic cover. Assure the metal tab is above the
plastic cover. Rotate plastic cover clockwise until CLOSE r
icon points toward top of watch.
5. Follow the pointed arrow and press with a paper clip the pad
in deep hole to reset.
6. Replace battery hatch. Rotate hatch clockwise, following
CLOSE arrow.
TIp: To help preserve battery life, you can turn the activity sensor off in the SYSTEM SETUP menu. Watch will
not count steps when sensor is off.
™ watch. Press MODE to select SETUP.
featUre
®
r
icon
8
feature. Beep will sound.
®
feature. Beep will sound. NIGHT-MODE
®
CLOSE
TO REMOVE/REPLACE
PRESS PAD
TO RESET
CR2032
®
CLOSE
ROTATE COVER
BATTERY
PRESS IN
HOLE WITH
PAPER CLIP