Cooling System Cleaning - Kawasaki FS730V - EFI Manual Del Propietário

32 MAINTENANCE

Cooling System Cleaning

Before each operation, check that the air inlet
(rotary) screen is free from grass and debris. Clean
the screen if necessary.
Check dust or debris inside fan housing. To check
inside, remove the air cleaner cover and see inside
from the inspection ports of fan housing. Clean or
blow the dust if needed. If it is difficult to clean the
dust with the ports, remove the fan housing and
clean the dirt completely.
Every 100 hours of operation, check and clean
the cooling fins and the inside of engine shrouds
to remove grass, chaff or dirt clogging the cooling
system and causing overheating.
Cleaning procedures are as below.
●
Remove the air cleaner cover and cleaner element
assy.
●
Loosen the screws and remove the voltage
regulator.
●
Loosen the screws and remove the air inlet guard.
●
Remove torx bolts and remove the air inlet screen.
●
Loosen three bolts and remove three bolts at the
fan housing.
●
Remove the fan housing.
●
Clean and blow out the dust or debris from the
cooling fan and the engine body.
NOTE
○
Cover the inlet port of the throttle body to keep
dust out of the opening.
NOTICE
Do not run engine before all cooling system
parts are reinstalled to keep cooling as
intended.
A. Check the inlet screen.
B. Check and see dust from the inspection ports.
A
B