Stanley SHP 1600 Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
3
Slide cord hook holster (D) onto right side, when fac-
ing unit, of power washer unit (C) as shown.
This step does not require any screws.
Note:
5
F
E
Connect the other end of high pressure hose (E) to
spray gun (F) by inserting the silver metal tip of high
pressure hose into the fitting just ahead of trigger
guard. It will lock into spray gun with a "click". Con-
firm hose is locked into spray gun by slightly pulling
on hose. The hose is now securely attached to spray
gun.
press button on underside of gun
Note: DO NOT
when connecting hose to gun.
93902_16ARN027_1600_ENG-FR-SP.indd 7
D
OFF/O
ON/I
C
4
High Pressure Hose Assembly
Screw high pressure hose (E) clockwise onto bottom
front of power washer unit (C). Pull back collar and insert
o-ring post into water outlet far enough so collar can
thread onto outlet threads until hand tight. If it takes
fewer than six turns you have not properly tightened
the high pressure hose fitting. It is easier to position the
power washer in front of you to ensure that the threads
are started correctly. Failure to properly tighten high
pressure hose will result in the hose slipping or popping
off immediately upon turning unit on. Do not worry
about damage if this occurs–just reinstall and take extra
care when screwing on the high pressure hose fitting.
use pliers or locking pliers to tighten.
Note: DO NOT
6
F
E
2
To release hose (E) from spray gun (F), press button on
underside of gun toward trigger guard. The hose will
slide out from connection.
C
E
7
16/11/29 下午4:52