Festool DUPLEX LS 130 EQ Manual De Instrucciones página 8

Stirrer
Technical data
Power
Speed (no load):
Working strokes
Sanding stroke
Sanding shoe
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
Symbols
Warning of general danger.
Read the Operating Instructions/Notes!
Wear protective goggles.
Wear a dust mask!
Wear ear protection!
1 Intended use
As specifi ed, the machines are designed for sand-
ing wood, plastic, metal, composite materials,
paint/varnish, fi ller and similar materials.
With the SSH-LS130_B100 scraper (accessory), you
can scrape off fl oor and wall coverings, residual
glue, etc.
Materials containing asbestos must not be proc-
essed.
Thanks to its linear sanding movement, the LS 130
EQ is ideally suited for sanding battens, straight
profi les and in rebates.
For reasons of electrical safety the machine must
not be damp nor operated in a humid environment.
The machine may only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Before starting up, please observe the
following
2.1 General Safety Rules
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
LS 130 EQ Save all warnings and instructions for future
260 W reference.
4,000 - 6.,00 rpm The term „power tool" in the warnings refers
8,000 - 12,000 rpm to your mains-operated (corded) power tool or
4.0 mm battery-operated (cordless) power tool.
80 x 130 mm
1.7 kg 2.2
/ II
- The manufacturer's handling and processing
instructions must be observed without fail if ex-
plosive or self-igniting dusts are likely to occur
during sanding.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, especially
inhaling them, can represent a hazard for operat-
ing personnel or persons in the vicinity. Comply
with the safety regulations that apply in your
country. Connect the electric power tool to a suit-
able extraction system.
2.3
The typical values determined in accordance with
EN 60745 are:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance
Overall vibration levels (vector sum for three direc-
tions) measured in accordance with EN 60745:
Vibration emission level
(3 directions)
Uncertainty
The emission values specifi ed (vibration, noise)
were measured in accordance with the test con-
ditions stipulated in EN 60745 and are intended
for machine comparisons. They are also used for
making preliminary estimates regarding vibration
and noise loads during operation.
The emission values specifi ed refer to the main
applications for which the power tool is used. If the
electric power tool is used for other applications,
with other tools or is not maintained suffi ciently
prior to operation, however, the vibration and noise
load may be higher when the tool is used. Take into
account any machine idling times and downtimes to
estimate these values more accurately for a speci-
8
Tool-specifi c safety rules
Always wear protective goggles because
of possible dangers when sanding.
To protect your health, wear a P2 protective
mask.
Noise and vibration information
Wear ear protection!
83 dB(A)
94 dB(A)
K = 3 dB
2
a = 5.5 m/s
h
2
K = 2.0 m/s