Rear Panel - Fender 68 Custom Vibro Champ Reverb-amp Manual De Instrucciones

I. POWER: Turns amplifier on and off.
J. IEC POWER INLET/FUSE: Using the included power cord, con-
nect to a grounded outlet in accordance with the INPUT POWER
voltage and frequency specifed at power inlet. To check/replace
fuse, unplug power cord and pry fuse holder from power inlet;
replace fuse only with another of the same type and rating.
TYPE
POWER
INPUT IMPEDANCE
OUTPUT IMPEDANCE
SPEAKER
TUBES
FUSE
ACCESSORIES
DIMENSIONS
WEIGHT
For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SPECIFICATIONS
PR5955
Requirements: 65 watts
1 MΩ (input 1)
3.2Ω
One 10" Celestion® Ten 30 (3.2Ω)
One 6V6GTA (power)
F1.25AL 250V (100V-120V models)
Two-button footswitch (optional, PN 0994058000)
Width: 16.87" (42.85 cm)
20.4 lbs. (9.25 kg)
Product specifications subject to change without notice.

REAR PANEL

K. SPEAKER: Jack for onboard 3.2Ω speaker. If connecting a different
speaker to this jack, it should have an impedance of 3.2Ω.
L. FOOTSWITCH: Connect optional two-button footswitch here.
Output: 5 watts RMS into 3.2Ω @ 10%THD, 1kHz
136kΩ (input 2)
Two 12AX7A (preamp)
F1AL 250V (220V-240V models)
Fitted cover (optional, PN 7720493000)
Height: 14" (35.56 cm)
2
Depth: 8.12" (20.62 cm)