Flex BME 18.0-EC + LK 152 Instrucciones De Funcionamiento Originales página 35

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Loosen the locking screw on the parallel

guide (1.).
Adjust the parallel guide (2.).

Re-tighten the locking screw.

Notices for working with the burnishing
attachment
CAUTION!
When it is switched off, the sanding tool
continues to run briefly.
Working on level surfaces:
Hold the power tool firmly with both hands.

For surface finishing:
Place the power tool carefully on the surface
to be treated and guide it back and forth with
linear movements.
Fillet weld grinding attachment
LK 152
Changing the grinding disc
Remove the battery.

Open the FixTec quick clamping nut.

Open the lock for the quick clamping nut (1.).

Turn the quick clamping nut in anti-clock-

wise direction while holding the grinding
disc (2.).
Remove the grinding disc (3.).

Fit a new grinding disc (4.).

Tighten the quick clamping nut by turning

in clockwise direction (5.) and close the
lock (6.).
Swivelling the sanding arm
Notices for working with the fillet weld
grinding attachment
CAUTION!
When it is switched off, the power tool con
tinues to run briefly.
-
35