Symbols Used In This Manual; Symbols On The Device; Important Safety Information; Intended Use - Flex BME 18.0-EC + LK 152 Instrucciones De Funcionamiento Originales

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Contents
Symbols used in this manual . . . . . . . . 23
Symbols on the device . . . . . . . . . . . . . 23
Important safety information . . . . . . . . . 23
Noise and vibration . . . . . . . . . . . . . . . . 29
Technical data . . . . . . . . . . . . . . . . . . . . 30
Overview . . . . . . . . . . . . . . . . . . . . . . . . 31
Instructions for use . . . . . . . . . . . . . . . . 32
Maintenance and care . . . . . . . . . . . . . . 39
Disposal information . . . . . . . . . . . . . . . 40
conformity . . . . . . . . . . . . . . . . . . . . 40
Exemption from liability . . . . . . . . . . . . . 40

Symbols used in this manual

WARNING!
Denotes impending danger. Non-obser
vance of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a potentially dangerous situation.
Non-observance of this warning may result
in injury or damage to property.
NOTE
Denotes hints on use and important infor
mation.

Symbols on the device

Before switching on the power tool,
read the operating manual!
Wear protective goggles!
Disposal information for the old tool
(see page 40)!

Important safety information

Read before using the power tool and act
accordingly:
these operating instructions,
-
the "General safety instructions" on
-
the handling of power tools in the enclosed
booklet (leaflet no.: 315.915),
the currently valid site rules and the regula
-
tions for the prevention of accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations. Never
theless, when in use, the power tool may
pose a danger to life and limb of the user or
a third party, or the power tool or other items
could be damaged. The power tool may be
-
operated only
for its intended use,
-
in perfect working order.
-
Faults which compromise safety must be
repaired immediately.

Intended use

The drive unit BME 18.0-EC must be used
solely as a drive for the attachments described
-
below.
With the fillet weld grinding attachment
LK 152, the power tool is designed
- for commercial use in industry and trade,
- for grinding weld seams, particularly in
hard to reach areas in railing construction,
- for use with sanding/grinding discs and
accessories which are indicated in these
instructions or recommended by the man-
ufacturer.
With the burnishing attachment BS 50,
the power tool is designed
- for commercial use in industry and trade,
- for surface treatment, such as burnishing,
structuring, polishing, brushing, smooth-
ing, derusting or deburring steel, stainless
steel or non-ferrous metals,
- for use with tools that are offered by the
manufacturer for this machine.
Using this tool on wood surfaces is not per-
missible.
WARNING!
-
-
23