Flex BME 18.0-EC + LK 152 Instrucciones De Funcionamiento Originales página 33

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Mounting attachments
Place the required attachment on a level

work surface with the quick-release cou-
pling facing upwards.
Place the drive unit in the required position

for the attachment and press down until it
engages audibly (1.).
Close the clamping lever (2.).

Open the clamping lever on the attach-

ment (1.).
Place the drive unit in the required position

for the attachment and press down until it
engages audibly (2.).
Close the clamping lever (3.).

NOTE
If the attachment does not audibly engages,
move the spindle or drive pully of the tool a
bit, so that the coupling can interlock.
Loosen the locking screw (1.).

Place the drive unit on the quick-release

coupling (2.).
Re-tighten the locking screw (3.).

Removal of attachments
33