Electrode Welding (Mma) - GYS TIG 220 DC Manual De Instrucciones

ELECTRODE WELDING (MMA)

CONNECTIONS AND RECOMMENDATIONS
• Connect the cables, electrode holder and earth clamp in the connectors,
• Respect the welding polarities and intensities indicated on the electrodes boxes,
• Remove the electrode from the electrode holder when the machin is not in use.
Adjustable values
TIG WELDING WITH INERT GAS (TIG MODE)
CONNECTIONS AND RECOMMENDATIONS
Connect the earth clamp to the positive connector (+).
Connect the torch to the negative plug (–), the trigger cable and the gas hose.
Ensure that the torch is equipped and ready to weld, and that the consummables (Vise grip, ceramic gas nozzle, collet and collet body) are not
damaged.
TIG WELDING PROCESSES
The grey areas are not useful for this mode.
• TIG DC
This welding mode in direct current (DC) is designed for ferrous metal such as steel, stainless steel or even copper and its alloys.
• TIG DC Pulsed
This pulse welding mode chains high current pulses (I, welding pulse) then low current pulses (I_cold, pulses to cool the piece). This pulse mode
allows to assemble pieces while limiting high temperatures.
20
TIG 220 DC / 300 DC
MMA (MMA PULSE)
The grey areas are not useful for this mode.
0 - 100%
MADE IN FRANCE
A
A
MEM
V
V PROG
S / Hz
%
10
s
20
s
0
s
TIG
MADE IN FRANCE
A
A
MEM
V
V PROG
S / Hz
%
10
s
20
s
0
s
0 - 100%
TIG PULSE
The grey areas are not useful for this mode.
EN
MADE IN FRANCE
A
A
MEM
V
V PROG
S / Hz
%
10
s
20
s
0
s