Remote Control - GYS TIG 220 DC Manual De Instrucciones

SAVE AND LOAD WELDING SETTINGS
There are 10 memories in MMA and 10 in DC TIG.
Menu is accessed with the
MEM
PROG
Save settings
Once in program mode, select IN and press the access button.
Slect a program from P1 to P10. Press the access button and the current setting is saved.
Load an existing setting
Once in program mode, select OUT and press the access button.
Slect a program from P1 to P10. Press the access button and the setting is loaded.
COMMAND TRIGGER CONNECTOR
DB
P
L
Cabling diagram for the SRL18 torch.
Torch 2 triggers + poten-
tiometer

REMOTE CONTROL

The remote control operates in TIG mode and in MMA.
ref. 045699
Connection
1- Plug the remote control into the connection at the back of the machine.
2- The machine will detect automatically the remote control and open a selection menu:
Foot pedal selection.
Remote control with potentiometer selection.
CONNECT-5 (automate-robot) selection.
Remote control is connected but inactive.
TIG 220 DC / 300 DC
button.
1
P
5
torch
2
4
L
torch
2
3
Torch type
Torch 2 triggers
G
F
A
B
E
D C
External view
4 3
5
2
6 1
DB
NC
torch
Torch 1 trigger
D
045682
C
B
045675
A
Electric diagram according to remote control type.
EN
DB torch
3
4
L torch
2
2
DB + P
5
torch
1
Electric diagram according to torch type.
Wire description Pin
Common/Earth 2 (green)
Switch trigger 1 4 (white)
Switch trigger 2 3 (brown)
Common/Potentio-
2 (grey)
meter earth
5 V 1 (yellow)
Cursor 5 (pink)
23