EINHELL DS 5 Manual De Instrucciones página 5

1
Assembly
Screw the spray tube to the pistol grip (Figure 1).
Do not unscrew the overpressure valve (letter A,
Fig. 2)!
Check to ensure that the screw connections for
the hose at the spray gun handle and on the tank
are tight!
Starting up and venting
Screw out the pump by turning the pump grip
(counter-clockwise).
Fill the container up to no further than the 5 liter
mark with the preparation you want to spray.
Follow the instructions issued by the producer of
the preparation you are using.
Screw in the pump again (clockwise) until it is
tight.
Turn the pump grip slightly counter-clockwise in
order to release it from the bayonet lock.
Build up pressure in the container by pumping up
and down. You can build up more or less pressu-
re in the container depending on the force with
which you want to spray. The overpressure valve
(A) triggers at a positive pressure of 3 bar and
relieves any pressure exceeding this amount.
2
A
To spray, simply squeeze the pistol grip.
Spraying will stop as soon as you let go of the
pistol grip.
Clean the sprayer each time after you have used
it and leave it open to dry.
You can prolong the working life of the sprayer
by occasionally applying resin- and acid-free
grease (Vaseline) to the seal rings and collars.
Please note: Severe stress during transportati-
on, use and storage, negative environmental
factors (at the point of use and storage), and
poor maintenance and care may cause the
sprayer to suffer premature wear. Each time
before you use the sprayer it is important, there-
fore, to check that it is in safe and good opera-
ting condition and that there are at least no visi-
ble signs of external damage.
We recommend that you arrange for a specialist
or Service Center to check whether the sprayer
is still safe for operation as soon as you discover
any defects with a potentially negative effect on
safety and at least every 5 years.
GB
5