Important Safety Advice; Guidelines For The Operator - Tornado TV2 Manual De Operaciones Y Mantenimiento

BEFORE USE READ THESE INSTRUCTIONS AND RETAIN FOR FUTURE REFERENCE
1. General information
This commercial vacuum cleaner has been
designed for the collection of dust in indoor
areas. It should not be used in outdoor areas.
We recommend that any user not familiar with
carpet cleaning should
instructions fully before using the machine. If you
have any queries please contact the supplier who
you purchased the machine from or Tornado
Industries.
This machine must only be used for the
manufacturer's approved application.
use the machine where it is suspected that the
carpet, floor or upholstery contains health
endangering dust or debris such as asbestos or
chemical waste. If this is suspected do not
proceed, contact your supervisor, supplier or
Tornado Industries for advice.
The following instructions contain important
information about the machine and safety advice
for the operator.
Equipment must be operated, serviced and
maintained in accordance
manufacturer's instructions. If in doubt, contact
the supplier of your machine.
These instructions are valid for the following
models:
TV 2

1.1 Important Safety Advice

When using electrical equipment basic safety
precautions should be followed including the
following.
 Read all instructions carefully before use.
 This appliance is suitable for commercial use,
for example in hotels, schools, hospitals,
factories, shops, offices, rental businesses and
other than normal housekeeping purposes.
 This machine is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the machine by a person
responsible for their safety.
 Keep children and unauthorized persons away
from the machine when in use.
 Children should be supervised to ensure that
they do not play with the appliance.
 Before using the appliance, check that the
mains power voltage corresponds with the
voltage shown on the rating plate.
 All parts are to be positioned as indicated in the
instructions before using the machine.
IMPORTANT
read these user
Do not
with the
4
 Do not operate the machine if it malfunctions or
is damaged in any way. Contact an authorised
service agent for repair or adjustment.
 Do not operate switches or touch the mains
plug with wet hands as this may cause electric
shock.
 When unplugging pull the plug, not the supply
cord.
 Do not pull or carry by cord, use cord as a
handle, close a door on cord, or pull around
sharp edges or corners.
 Keep hair, loose clothing, fingers and all parts
of body away from openings and moving parts.
 Keep cord away from heated surfaces.
 Do not use where hazardous dust is present.
 Do not use in an explosive atmosphere.
 Do not pick up oil or other flammable material.
 Do not use to pick up moisture or any liquids.
 Do not leave the machine connected to the
electricity supply when not in use; always
remove the plug from the socket-outlet.
 Switch off the machine before removing the
plug.
 Keep the power supply cord clear of moving
parts. During operation hazard may occur
when running the machine over the power
supply cord.
 The power supply cord must be regularly
inspected for signs of damage. If the power
supply cord is damaged, it shall only be
replaced by the manufacturer, its service agent
or a similar qualified person in order to avoid a
hazard.
 Only replace the supply cord with the type
specified in the instruction manual.
 Do not operate the machine with a damaged
supply cord or plug, or after the machine
malfunctions or is damaged in any way.
Contact an authorised Service Agent for repair
or adjustment.
 The plug of the power supply cord must be
removed from the
commencing cleaning of the machine or
undertaking maintenance operations.
 Do not kink or twist the power cord.
 Take care when using a machine near the top
of stairs to avoid overbalancing.

1.2 Guidelines for the operator

WARNING
Operators must be fully trained in the
use of the machine in accordance with
these instructions, able to perform user
maintenance and the
accessories.
 Operators should be physically capable to
manoeuvre, transport
machine.
socket-outlet before
correct selection of
and operate the