Troubleshooting; Service Information - OHAUS Scout SPX Serie Manual De Instrucciones

TM
SCOUT SERIES BALANCES - SPX
5. MAINTENANCE
5.1 Cleaning
The housing may be cleaned with a cloth dampened with a mild detergent if necessary.
Attention: Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean the housing
or control panel.

5.2 Troubleshooting

The following table lists common problems and possible causes and remedies.
If the problem persists, contact OHAUS or your authorized dealer.
Symptom
Cannot turn on
Poor accuracy
Cannot calibrate

5.3 Service Information

If the troubleshooting section does not resolve or describe your problem, contact your
authorized OHAUS service agent. For service assistance or technical support in the United
States call toll-
product service specialist will be available to provide assistance. Outside the USA, please visit
our web site,
Find Quality Products Online at:
WARNING: Electric Shock Hazard. Disconnect the equipment from the power
supply before cleaning. Electric Shock Hazard.
TABLE 5-1
Possible Cause
No power to balance
Improper calibration; Unstable environment
Security switch in locked position
Weight exceeds power on zero range.
Weight below power on zero range.
Over load (weight exceeds rated capacity)
Under load (pan removed)
Tare out of range
Displayed value exceeds 999999 (possible in Totalization mode)
Parts counting or percentage error
error then exits parts counting or goes to [
Percent Reference weight or APW is too low for accurate results
Fail to do calibration.
Cannot find menu or app file in U-disk.
- - -
to locate the OHAUS office nearest you.
GlobalTestSupply
www.
sample weight <1d. Balance shows
between 8:00 AM and 5:00 PM EST. An OHAUS
.com
EN-15
].
sales@GlobalTestSupply.com