Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAIN PARTS

CONTROL PANEL
THERMOSTAT KNOB
POWER SWITCH KNOB
VENTILATION OUTLETS
CORD HOLDER
ASSEMBLY
1. To remove the casters from the package.
2. Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint
finish.
3. Put the U type screws through the bottom of oil tank, make them through the 2 wheel plate
supporter which already fixed.
4. Tighten the 2 pcs M5 screws putted into the overhang of U type screw which was already made
through from the wheel plate supporters to make sure that the 2 holes of wheel plate are
exactly match the overhang of U type screw which is putted through the wheel plate
supporters,tighten the 2 pcs butterfly screws putted into the overhang of U type screw which is
already putted through wheel plate supporters.
Note: For 7 fins, assemble wheel panel under the control box.
5. Turn the unit upright.
CAUTION – Risk of fire – Do not operate without casters attached.
CAUTION – Operate the heater in upright position only casters on the bottom; controls on the top).
Any other position could create a hazardous situation.
WHEEL PANEL
- 10 -
FINS
WHEEL

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ny7c-9Ny7c-11

Tabla de contenido